Huangshan liangye Valve Co., Ltd. attended the nat

2022-08-21
  • Detail

Huangshan liangye Valve Co., Ltd. attended the working meeting of the national science and technology support plan "research and application of key technologies for urban lifeline safety assurance"

Huangshan liangye Valve Co., Ltd. attended the working meeting of the national science and technology support plan "research and application of key technologies for urban lifeline safety assurance"

also enhanced the economic feasibility of mining technology support plan The working conference on the topic of "research and application of key technologies for urban lifeline safety assurance" was held on August 21, 2015 in 8 There is a needle valve on the side of the working oil cylinder of the rubber universal testing machine. If its position is adjusted improperly, the pressure of the testing machine cannot rise to high tonnage. At this time, the position of the nut and screw should be adjusted repeatedly to make the oil valve seal the oil circuit, so that the oil exuded by the oil cylinder and piston does not return to the oil tank along the oil return pipe. Loosen the screw, and the air in the U-shaped leather ring can also be removed. The meeting was presided over by Yang Qianjin of the General Academy of Mechanical Sciences, the undertaking unit, and delivered a speech by Li Yaping, vice president. The research units attended the meeting

the working meeting on the topic of "research and application of key technologies for urban lifeline safety assurance" of the science and technology support plan was held in Huangshan City on August 21, 2015. The meeting was presided over by Yang Qianjin of the General Academy of Mechanical Sciences, the undertaking unit, and delivered a speech by Li Yaping, vice president

the research units attended the meeting

the participating units of each research group reported the completion of the task. 2. The spot welding of hot-rolled steel bars should be used as a shear test, and then the expert group raised questions. According to the opinions and suggestions of experts, each research group had a serious discussion and exchange, and finally, a summary of the meeting was made

xiangmeigen, the chairman of our company, senior engineer, and xiangxiaoming, the general manager, and other relevant technical personnel attended the meeting

the third research group of the project: research and application of key technologies for safety assurance of urban lifeline (National Academy of Mechanical Sciences). As a sub project unit of the project, our company is mainly responsible for: Research on emergency response and equipment for sudden disaster accidents of urban lifeline, research and development of intelligent control devices, and organizing the application demonstration of valve control devices in Yantai Economic and Technological Development Zone and other units

in the afternoon, all participants came to Huangshan liangye Valve Co., Ltd., the R & D and production unit of the subject equipment, to demonstrate the on-site wireless application of the control equipment. Practice has proved that the "intelligent valve control device" operates normally without any failure, and the expected goal has been achieved

finally, experts discussed and agreed that the "intelligent valve control device" developed by Huangshan liangye company met the requirements

Copyright © 2011 JIN SHI